Skip to main content

Trans Adriatic Pipeline route

The Trans Adriatic Pipeline (TAP) will start near Kipoi on the border of Turkey and Greece, where it will connect with the Trans Anatolian Pipeline (TANAP).

From there, TAP will continue onshore, crossing the entire territory of Northern Greece, its longest stretch, then onwards east to west through Albania to the Adriatic coast.

The offshore section of the pipeline will begin near the Albanian city of Fier and it will traverse the Adriatic Sea to tie into Italy’s gas transportation network in Southern Italy.

TAP will be 878 kilometres in length (Greece 550 km; Albania 215 km; Adriatic Sea 105 km; Italy 8 km). Its highest point will be approximately 2,100 metres in Albania’s mountains, while its lowest will be 810 metres beneath the sea.  

Please, use the interactive dynamic map below to see the current proposal for TAP's routing.


The pipeline route is now fixed. Some minor changes could potentially occur to accommodate unknown issues, such as, the discovery of a previously unknown archaeological site.

The information contained in this GIS map is provided and maintained by various companies, including a number of TAP contractors and sub-contractors. No guarantee is given as to the accuracy or currency of any of the data. The data layers presented on this website have been compiled for information purposes only.


The depiction and use of boundaries, geographic names and related data shown on maps are not warranted to be error free nor do they imply official endorsement or acceptance by the Trans Adriatic Pipeline (TAP) AG.

The pipeline in Greece will be approximately 550 km long, starting at Kipoi near the Turkish-Greek border and finishing at the Greek border with Albania, south-west of Ieropigi.

The pipeline in Albania will be approximately 215 km long, starting at Bilisht Qendër in the Korça region, on the border with Greece. TAP’s landfall in Albania will be located 17 km north-west of Fier, up to 400 metres inland from the shoreline. The offshore section in Albanian territorial waters will be about 37 km.

Adriatic Sea
TAP’s route across the Adriatic Sea will take the pipeline approximately 105 km along the seabed from the Albanian to the Italian coast.

TAP will make landfall in southern Italy, in Lecce, municipality of Melendugno, near San Foca. The offshore pipeline through Italian territorial waters will be about 25 km long while the onshore section will be approximately 8 km. The location was chosen after eleven alternative pipeline route assessments as the most feasible from environmental, safety and social perspectives.

Please note that the above figures are estimates and could change as the project develops.